Page 1 of 1

Cut & Splice bug?

PostPosted: Wed Mar 14, 2007 11:51 pm
by essanddee
Hi there,

Not sure if this is a bug or not but I notice that whenever I perform a Cut & Splice that the Horizontal Div setting gets changed from whatever I have set it on back to "2000" and I have to rest it again.

PostPosted: Thu Mar 15, 2007 10:19 pm
by Derek
That's not a bug but a feature!

When you use cut & splice, the display is rescaled so that the edges of the cross fade region are visible.

PostPosted: Fri Mar 16, 2007 1:48 am
by essanddee
Thanks Derek.

Yes, I see what you mean - it is just something I do not bother about. Once I have decided on the actual cut size and having auditioned before/after etc. I just perform the cut/splice without any attention to the cross fade region. Most cut slices tend to be pretty miniscule and not noticeable unless one is cutting out portions where the vinyl is bad enough to cause the pickup arm to get stuck and repeatedly jump.