This forum is for discussing Wave Corrector, audio projects, tips & tricks etc.

Moderator: Derek


Postby MuzakMan » Sun Jul 30, 2006 10:05 am

Hi to everyone This subject must have been raised in the the past, but as I am new to the group here is my question. What is the best way or filter to use when recording /ripping down very old 78 that give a lot of track noise. Any help you can give !! ?
Posts: 2
Joined: Sat Jul 29, 2006 11:22 pm

Postby citguy » Mon Jul 31, 2006 3:57 am

I did about 240 78's a couple of years ago. You have to test your filter settings for each disk. The noise is not really hiss as we know it and over use of a filter will destroy any content. I found cutting the treble as much as possible was generally the best for my purposes. I doubt if you can get a good "noise pofile" because of the frequency of the noise. I never could master the "graphic equalizer" but there may be some promise there.

Posts: 151
Joined: Sun Jan 09, 2005 4:32 pm
Location: Portland, Oregon USA

Postby Derek » Mon Jul 31, 2006 1:53 pm

Surface noise from 78's (crackle) is the most difficult type of noise to remove. It is too spiky to be susceptible to a hiss filter, but too continuous for click removal to be fully effective. There is a good article on this at http://www.cedar-audio.com/intro/intro.html that you might find interesting.

Using Wave Corrector for this, the best advice is to make multiple passes of the click filter. Use the Superscan command on the Waveform menu and set the number of passes to at least 3. You will need to experiment to find the optimum values for number of passes versus click detection threshold.

Having removed most of the crackle, you could then apply the hiss filter although I'd advise against over-filtering as the effect willl be detrimental to the music.

As Stan says, you can also apply some treble cut.

Some other factors worth considering:

1. Use the speed conversion option in Wave Corrector to record your 78's at 45rpn. This has the advantage that the tracking velocity is lower and therefore there should be less tracking distortion.

2. Experiment with different styluses. You find one othat tracks a portion of the groove that is less worn.

3. At the end of the de-noise process, convert your stereo recording to mono. Unfortunately, you cannot use Wave Corrector for this but it will theoretically gain you an extra 3db of S/N ratio.

Finally you may find this thread interestiing: http://www.wavecor.co.uk/phpBB2/viewtopic.php?t=23. Although I haven't yet implemented this suggestion, I may do so if there is sufficient demand.
Derek Higgins
Wave Corrector Developer
Site Admin
Posts: 476
Joined: Sat Jan 01, 2005 7:57 pm
Location: Coleshill, United Kingdom

Thanks Guys

Postby MuzakMan » Tue Aug 01, 2006 9:07 am

I will try out all these options and will report back my results soon

best regards to all and thanks

Posts: 2
Joined: Sat Jul 29, 2006 11:22 pm

Return to Chat

Who is online

Users browsing this forum: No registered users and 1 guest